NEC NDA-24298 manual Atcp Assignment of Time/Pattern Change Information Data

ATCP : Assignment of Time/Pattern Change Information Data

ATCP: Assignment of Time/Pattern Change Information Data

1.General

This command assigns the time period corresponding to each Time of Day Change Pattern Number (TDPTN). These Time of Day Change Patterns are used to change the routes to be used during a specific time period so that trunks can be used effectively and call charges can be kept to a minimum.

2.Precautions

1.The data assigned by this command is required for the ACBC/AOPR/ASDC commands. However, when the Clocked Manual Override data is assigned by the ACMO command (used for changing routes during a specific time period), the ACMO data has priority over data assigned by the ATCP command to the ACBC/AOPR/ASDC commands.

2.Assignment intervals must be at least 30 minutes.

3.If the time data is assigned in duplicate, the latter assignment shall take effect. For example, “9:00 ~ 12:00 = TDPTN 1” is set then “11:00 ~ 15:00 = TDPTN 2” is specified, the time setting “9:00 ~ 11:00 = TDPTN 1”/“11:00 ~ 15:00 = TDPTN” is to be executed.

3.Data Entry Instructions

		TIME DATA FOR TDPTN				TIME OF DAY
	(FROM)			(TO)		CHANGE	REMARKS
						PATTERN
						(TDPTN)
HOUR		MINUTE	HOUR		MINUTE
						0-7
09	:	00	20	:	00	0
20	:	00	09	:	00	1
	:			:		2
	:					3

TIME DATA FOR TDPTN

The time period TDPTN is effective.

TDPTN

Enter the pattern number corresponding to the TDPTN assigned at AOPR/AOPRL/ASDC commands. Note

Note: “TDPTN = 0” is also used in default setting (in unspecified time period). Thus the assignment “TDPTN = 0” means nothing in this command.

NDA-24298CHAPTER 4

Page 297

Issue 1