NEC NDA-24298 manual Aisa Assignment of Individual Calling Entry Area

AISA : Assignment of Individual Calling Entry Area

AISA: Assignment of Individual Calling Entry Area

1.General

This command designates the station type (MST or SLV) and the number of memory blocks to be used for the Speed Calling Group/Station.

2.Precautions

1.One (1) Speed Calling - Station memory can be assigned a maximum of 18 digits for the long speed dial number.

2.One (1) BLOCK consists of ten (10) Speed Calling - Station memories.

3.There are one hundred (100) BLOCKs per MG.

4.The applicable Tenant Number (TN) range is designated by the ASYD command, SYS 1, INDEX 8.

5.The MST station user can register the speed dial number and also originate a speed dial call.

6.The SLV station user can originate a speed dial call, but speed dial number registration is not available. The speed dial number registration is done by the MST station only.

7.The MST station and slave stations must be in the same MG.

8.The AISD command allows the maintenance person to register the speed dial number.

9.When assigning the individual speed calling entry block of the Attendant Console, use the Specific Attendant Number previously assigned in the ASAT command.

3.Data Entry Instructions

MST/SLV

M = MST

S = SLV

BLOCK

The BLOCK parameter is displayed when MST/SLV = M

TENANT	MST STATION NUMBER	STATION	NIUMBER OF BLOCKS	SLV STATION
NUMBER	(STN)	TYPE	(BLOCK)	NUMBER
(TN)		M/S)	1-10	(STN)
1	300	1	1
1	300	2		330

STN

The STN parameter is displayed when MST/SLV = S

NDA-24298CHAPTER 4

Page 717

Issue 1