NEC NDA-24298 manual When FUNC=1 and TYPE=1/2 are assigned

AEVT : Assignment of Virtual Tie Line Data for Event Based CCIS

AEVT: Assignment of Virtual Tie Line Data for Event Based CCIS

1.General

This command assigns Virtual Tie Line data for Event Based CCIS.

2.Precautions

1.When the parameter Verification of Connection (VRY) is assigned as “1,” if the Calling party number is not the same as the number assigned in the parameter CALLED, connection is not established.

2.The parameter FUNC = 2 is necessary to activate Event Based CCIS using the private ISDN line.

3.Data Entry Instructions

♦When FUNC=1 and TYPE=1/2 are assigned

		TYPE
	1=Separate Channel System
	2=Separate Channel System (for Call-By-Call)				DESTINATION
	3=Common Channel System				E-CCIS trunk
	4=Common Channel System (When "NPI" and
					identification number.
	"TON" are assigned by the ACBC command)
FUNCTION		ROUTE	TRUNK		DESTINATION
		NUMBER	NUMBER	TYPE	NUMBER
		(RT)	(TK)	1-4	(DESTINATION)
		1-255	1-255		6 DIGITS
1

CALLING

DID number for incoming call from an E-CCIS

CALLING NUMBER

(CALLING)

1-24

CALLED

DID number for outgoing call

CALLED NUMBER

(CALLED)

1-24

CCIS_RT/CCIS_TK			VRY
Assign CCIS signal route and		Verification of connection
		0=Not required
trunk number.
		1=Required
CCIS_RT CCIS_TK		VRY	OPR	RA
1-255	1-255	0/1	1-4000	0-7

Note: "OPR" and "RA" parameters appear for TYPE=2.

OPR Note

Assign Outgoing Route

Selection pattern number.

NDA-24298

RA Note

Assign the order of route advancing.

CHAPTER 4

Page 845

Issue 1