NEC NDA-24298 manual Pad Control Data

				ALRNN : Assignment of Logical Route and Route Class Data for NDM
LOGICAL ROUTE (LGRT) 1-899
FUSION POINT CODE (FPC) 1-253												REMARKS
ROUTE NUMBER (RT) 1-255
		Trunk Override Calling
91	TOCI	0	= Override Inhibited (Calling side).
		1	= Tie Line Override Service is provided (Calling side).
		Trunk Override Called
92	TOCD	0	= Override Inhibited (Called side).
		1	= Tie Line Override Service is provided (Called side).
93	ODGD							0	0	0	0	Always assign data “0.”
94	RLS							0	0	0	0	Always assign data “0.”
		Gate Way Data Service
95	GWD		0= Out of Service		1	=	Gate Way System
		2-15= Not used
96	H1	ISDN H1 Switching						0	0	0	0	Always assign data “0.”
		0	=	–	1	=	In Service
97	DT							0	0	0	0
		ISDN transmitting information
			0 = Out of Service
98	CI		1 = 16-Digit Caller Number Service, Attribute Informa-
				tion Notification Service, and Calling Sub-Address
				Transfer Service
		2-15= Not used
99	OID							0	0	0	0	Always assign data“0.”
100	TKS							0	0	0	0	Always assign data“0.”
		Pad Control Data 2										PAD value can also be set
												by switch setting on the
101	PAD2	0-7 =		For Pad value, See the NEAX2400 IPX Circuit Card
												8TLT (Long Line
				Manual.
												Telephone = TELT) card.
102	TRM							0	0	0	0	Always assign data “0.”
103	TRPX							0	0	0	0	Always assign data “0.”
104	LDR							0	0	0	0	Always assign data “0.”
105	TSC							0	0	0	0	Always assign data “0.”
106	SATS							0	0	0	0	Always assign data “0.”
107	RVPX							0	0	0	0	Always assign data “0.”
108	DQ							0	0	0	0	Always assign data “0.”
109	SLOV	Slumber Time Override Service						0	0	0	0
		0	=	Out of Service	1	=	In Service
		System message automatic output when Connection Ac-
110	SDTO	knowledge signal has not been received.
		0	=	Out of Service	1	=	In Service
111	ADVPRA	ISDN PRI Failure Routing Service										This data is valid for
		0	=	Out of Service	1	=	In Service					dummy routes.
112	IND	Inter-office Name Display
		0	=	Out of Service	1	=	In Service
113	UUI							0	0	0	0	Always assign data “0.”

NDA-24298CHAPTER 4

Page 565

Issue 1