NEC NDA-24298 manual ADA1T Assignment of DTE Attribute Data 1 Telephone Number

ADA1_T : Assignment of DTE Attribute Data 1 – Telephone Number

ADA1_T : Assignment of DTE Attribute Data 1 – Telephone Number

1.General

This command is used to assign and delete Attribute Data 1 for each terminal (DTE). Attribute Data 1 is stored as the office data of the switching unit, and is rarely modified in normal operation. Attribute Data 2, on the other hand, is stored on the data terminal side and is modified in the course of operation. The station data can be assigned by using Telephone Number.

2.Precautions

1.Only the Telephone Numbers assigned by the ALGSN command can be used. Telephone Numbers by the ALGSL command is not available in this command.

2.In case logging in to a LN, only the Telephone Numbers allocated to the stations within the logged-in node can be used in this command. Also, when logging in to the NCN, the data memory of the whole nodes in the network can be written.

3.This data can be set for the following TEC (Telephone Equipment Class): TEC = 13 (DTE via Dterm)

Refer to ASDT/AAST command.

3.Data Entry Instructions

See the data sheet in Section 4.

NDA-24298CHAPTER 4

Page 505

Issue 1