NEC NDA-24298 manual Arac Assignment of Remote Access Code

ARAC : Assignment of Remote Access Code

ARAC: Assignment of Remote Access Code

1.General

This command is used when the system provides the Remote Access to System service feature for a TIE line or DID line.

2.Precautions

1.The Remote Access to System service feature is activated when the access code (assigned at ACC parameter of this command) is called from a TIE line or a DID line. This command assignment is not required when the Ring Down method incoming route is applied to the Remote Access to System service feature.

2.The tenant number of the Incoming Trunk (ICTK) is assigned by the ATRK command.

3.The ACC should be assigned a unique number conformable to the station number (STN) assigned by the numbering plan data.

4.When the ASYD command, INDEX43, bit0=0 (Authorization Code required with Remote Access to System service feature) is assigned, the AATC/AMND command should also be assigned. In this case, the TN parameter of this command should correspond to the tenant number assigned by the AATC command.

5.To accomplish the Remote Access to System service feature, the following commands should also be assigned:

•ARTD command, FA = 1

•ASTD command, STM = 4, SYS = 0, ST = 1

•ACSI command

•ACFR command

•ARRC command

CHAPTER 4 NDA-24298

Page 358

Issue 1