NEC NDA-24298 manual FKY = 51 MIC, Default Data for Each Line/Feature Button, KEY Default Data

AKYD : Assignment of Key Data for Dterm

5.A virtual line can be assigned as a Sub Line of the Dterm. The virtual line can be used the same way as the My Line for outgoing calls and other service operations.

Note: Virtual Line --- A virtual LENS exists only in memory, but does not exist physically. Data can be assigned but no hardware is required:

Example: LENS = 000311. The virtual LENS is assigned by the ASDT command in the same way as an ordinary line. (The telephone class is TEC = 18: Virtual Line)

6.If the station user accepts the default settings, the data assignment of this command is not required. The default data for each line/feature button is shown in Table 4-11.

Table 4-11 Default Data for Each Line/Feature Button

KEY	DEFAULT DATA	KEY	DEFAULT DATA
NO.		NO.
1	CALL PICKUP	9	PRIME LINE
2	CALL FORWARDING - BUSY LINE	10	SPEED CALLING ONE-TOUCH
3	CALL FORWARDING - ALL CALLS	11	SPEED CALLING ONE-TOUCH
	CALL FORWARDING - DON’T ANSWER
4	EXECUTIVE RIGHT OF WAY	12	SPEED CALLING ONE-TOUCH
5	VOICE CALL	13	SPEED CALLING ONE-TOUCH
6	MESSAGE REMINDER	14	SPEED CALLING ONE-TOUCH
7	SAVE AND REPEAT	15	SPEED CALLING ONE-TOUCH
8	LAST NUMBER CALL	16	SPEED CALLING - SYSTEM

7.The ability to assign Sub Line appearances across module groups is available when ASYD command SYS1, INDEX321, bit0 = 1 is assigned. Stations can appear on Dterm which accommodated the different module group within the same IMG.

8.When assigning the line/feature buttons as function keys, take the following precautions:

(a)My Line key must be programmed.

(b)Not used line/feature buttons should be assigned as KYI = 0 (Not used)

(c)The following function keys are basically fixed:

FKY = 13: CONF (Three - Way Calling)

FKY = 18: TRANSFER (Call Transfer - All Calls)

FKY = 20: HOLD (Non - Exclusive Hold/Exclusive Hold)

FKY = 28: ANSWER

FKY = 51: MIC

FKY = 52: SPEAKER

FKY = 57: RECALL

CHAPTER 4 NDA-24298

Page 438

Issue 1