NEC NDA-24298 manual Adrtn Assignment of Dterm Display Route Data for NDM

ADRTN : Assignment of Dterm Display Route Data for NDM

ADRTN: Assignment of Dterm Display Route Data for NDM

1.General

This command changes the display of trunk class information on the Dterm instead of the Trunk Class (TCL) designation of the ARTD command.

This data is written in Network Data Memory (NDM) of the Network Control Node (NCN).

2.Precautions

1.The Route Class information is displayed on all Dterms of all nodes in the Fusion Network.

2.The data assigned by this command has priority over the data assigned by the ADRTL command.

3.This data is not available for ISDN stations and PS.

4.When a call terminated from the trunk COC number has been assigned by ACOC command, the following is displayed on the Dterm as to “TYPE” parameter;

•TYPE = 1 (4 characters) is entered, both COC number assigned by ACOC command and 4-character trunk class assigned at “DISP” parameter is displayed.

•TYPE = 2 (8 characters) is entered, only the 8-character trunk class assigned at “DISP” parameter is displayed.

3. Data Entry Instructions

LGRT

Assign Logical Route number at NCN in the Fusion Network.

DISP

The characters displayed on the Dterm.

Logical Route

Number

(LGRT)

1-899

Character

Display Type

(TYPE)

1, 2

Display for Trunk Class on Dterm

(DISP)

REMARKS

TYPE

The maximum number of characters 1 = 4 (4 bytes ASCII characters)

2 = 8 (8 bytes ASCII characters)

CHAPTER 4 NDA-24298

Page 478

Issue 1