NEC NDA-24298 manual Depending on the Dterm Series III or Dterm Series E

ASYD : Assignment of System Data

	SYSTEM			BIT
SYSTEM		DATA	CORRESPONDING
	DATA
DATA		(DATA)		DATA
	INDEX									SYSTEM DATA CONTENTS
TYPE		00 – FF
(SYS)	(INDEX)	(Hex)	DATA
	0 – 511				BIT
			0/1
					b0		Control of ORT all Busy Status
							0/1 = ROT/Queue
							Recalling method when the caller has released with Emergency
							Call service
						0/1		=	SHF or Depressing Ground Button/Unconditional Re-
					b1				calling
						Note: The operation procedure for recall is					different
									depending on the Dterm Series III or Dterm Series E.
									Dterm III user operates with SHF.
									Dterm E user operates with transfer key.
					b2		Releasing Method for Station to Station Calling Service
							b3	b2
						0		0	=	Calling Party release
					b3	0		1	=	Called Party release
						1		0	=	First Party release
						1		1	=	Both Party release
1	4						Normally assign “First Party release”
							Temporary Class Conversion/OAI Free Location Memory
							0/1 = Not Required/Required
					b4	Note:			When setting outgoing restriction and toll restriction in
									CCIS using the caller’s RSC transferred by a call
									origination from the preceding office, data value “1” is
									assigned. Destination restriction and		number
									restriction cannot be made using RSC. This data is
									assigned “1” when the authorization code is provided.
							PAD Control of 16LC circuit card (for Station to Station Calling
					b5		only)
							0/1: Required/Not Required
							One Burst of Ringing On Call Forwarding (C.F.) phone when
					b6		C.F. – All Calls service has been assigned (analog phones only).
							0/1 = Not Required/Required
					b7		Emergency Call Printout
							0/1 = No Printout/Printout

NDA-24298CHAPTER 4

Page 63

Issue 1