NEC NDA-24298 manual Diagnosis, designate the number of LP to be executed, Console is effective

ASYD : Assignment of System Data

	SYSTEM	DATA		BIT
SYSTEM			CORRESPONDING
	DATA	(DATA)
DATA				DATA
	INDEX	00 – FF					SYSTEM DATA CONTENTS
TYPE
(SYS)	(INDEX)	(Hex)	DATA
	0 – 511				BIT
			0/1
							Configuration of CPU (for IPX)
					b0		0/1 = Single/Dual
							For IPX, assign “0.”
			0		b1		Not used
			1		b2		Trunk Ineffective Hold Detect Processing Program Start
							0/1 = Not Required/Required (Always assign “1.”)
			1		b3		Send Forced Off-Hook Supervisory Command
							0/1 = Not Required/Required (Always assign “1.”)
			0		b4		Not used
	58		0		b5
							LP Residual Link Detect (for IPX-UMG system only)
							0 = All LP per a day
							1 = 1 LPG per a day (1LPG consists of four IMGs)
					b6		Note: As related to the total necessary time of Routine
							Diagnosis, designate the number of LP to be executed
							the LP Residual Link Detect per a day. This data is
							effective when ASYD SYS1 INDEX90 bit3=1 (Residual
1							Link Detect is to be executed) is assigned.
			0		b7		Not used
					b0		Incoming Call Restriction from TRK during Line Load Control
							0/1 = Not Required/Required
							LCR – Controlled Alternate PRSC (FRLs) service (urgent mode
							via AUNE)
					b1		0/1 = Out/In Service
							Note: When “1” is assigned, the FRL key on the Attendant
							Console is effective.
					b2		DID Busy Condition
	59						0/1 = No Tone/Busy Tone
			0		b3		Not used
			0		b4
			0		b5		Number of Tones sent for Override services
							0/1 = 2/3 Tones
			0		b6		Send Tones for Attendant and Override services
							0/1 = Yes/No
					b7		Intercom service for Dterm
							0/1 = Out/In Service
CHAPTER 4						NDA-24298
Page 82
Issue 1