NEC NDA-24298 Akyd Assignment of Key Data for Dterm, Data Assignment for the Dterm Type of D term

AKYD : Assignment of Key Data for Dterm

AKYD: Assignment of Key Data for Dterm

1.General

This command assigns the following key data corresponding to each line/feature button on a Dterm.

•Line Key Data

•Function Key Data

•Intercom Key Data

•DSS Key Data

2.Precautions

1.The Dterm Series III (16-button type) and Dterm Series E have the default key data. (Refer to Precautions

6.) If the default data is to be used, assignment in AKYD is not necessary. Table 4-10shows the specifica- tion pertaining to data assignment for the Dterm.

Table 4-10 Data Assignment for the Dterm

TYPE OF Dterm		LINE/FEATURE BUTTON	NUMBER OF BUTTONS
	8-button type	KYN = 1-8	8
Series III	16-button type	KYN = 1-16	16
	24-button type	KYN = 1-24	24
	8-button type	KYN = 1-8	8
Series E	16-button type	KYN = 1-16	16
	32-button type	See Figure 4-7	32

2.Before assigning the key data for a Dterm using this command, be sure to assign the station data of the Dterm using the ASDT command (TN, STN, TEC = 12 (Dterm)). The station number assigned by the ASDT command is referred to as “MY LINE”.

Note: This “MY LINE” corresponds to the physical port associated with the LENS of a ELC card.

3.By assigning another station line to a feature button using this command, an incoming call terminated to a station line other than My Line can be answered or can be transferred to elsewhere as in the case of the My

Line. A station line other than My Line is referred to as a “Sub Line.” A “Sub Line” can be assigned not only to a Dterm but to any conventional telephone. In addition, the station data for My Line and Sub Line must be assigned by the ASDT command before the key data is assigned. When the Sub Line and the My Line belong to different tenants, use the ATNR command and clear the “Tenant-to-Tenant Restriction.”

4.A Multi-Line key (the key for My Line and Sub Line) on the Dterm can be assigned as Prime Line. If the

Prime Line is not assigned, the My Line serves as the Prime Line. When the user goes off-hook, the Prime Line is automatically selected on the Dterm.

NDA-24298CHAPTER 4

Page 437

Issue 1