NEC NDA-24298 manual Amnd Assignment of Maximum Necessary Digits Data

AMND : Assignment of Maximum Necessary Digits Data

AMND: Assignment of Maximum Necessary Digits Data

1.General

This command assigns the number of necessary digits to be received by the Register (ORT/IRT) circuit.

2.Precautions

1.When the dialed number for the outgoing call is started as assigned by the DC parameter, and when the digits specified by the MND parameter have been dialed, the following happen simultaneously.

(a)The SND circuit starts to transmit the number information to the external trunk route.

(b)The Originating Register (ORT) circuit is released.

If the originating party dials more digits after the MND, and the data in the ASYD command is SYS1, INDEX43, bit7 = 1, the call is restricted.

2.The applicable Tenant Number (TN) range is designated by the ASYD command, SYS1, INDEX8. If data for this command is common for all tenants (ASYD command, SYS1, INDEX93, bit6=1), assign the TN parameter as data “1” for all tenants.

3.If the Authorization Code service is used, split tenants using the ASYD command. (SYS1, INDEX93, bit6=0)

4.For the Authorization Code service feature, enter the following:

TN	=	0 (Tenant number zero)
DC	=	Enter the first digit of the Authorization Code (assigned by the AATC command).
MND	=	Enter the number of “Authorization Code digits + Check Sum 2 digits (if the checksum method
		is applied by the ASYD command, SYS1 INDEX12 -14)”
TOLL =		0
AN	=	0
RATE =		0
A/D	=	0

CHAPTER 4 NDA-24298

Page 264

Issue 1