NEC NDA-24298 manual Afrsl Assignment of Flexible Route Selection Data for LDM

AFRSL : Assignment of Flexible Route Selection Data for LDM

AFRSL: Assignment of Flexible Route Selection Data for LDM

1.General

This command assigns the area and/or office code data for the OPR assigned by the AOPRL command. This data is written in Local Data Memory (LDM).

2.Precautions

1.The applicable Tenant Number (TN) range is designated by the ASYD command, SYS1, INDEX8. If data of this command is common for all tenants (ASYDL command, SYS1, INDEX800, bit4=1), assign TN parameter as data “1” for all tenants.

2.After an Outgoing Route Selection Pattern Number (OPR) has been assigned in this command, it is necessary to assign the LCR routing pattern/six (6) digits routing pattern by the AOPRL/ASDCL command respectively.

3.The access code may or may not be included in the Number Pattern Code (NPC) depending upon the assignment of the AC parameter by the ARTD command. If zero (0) is assigned, the access code is not included. If one (1) is assigned, the access code must be included.

4.Assign the dummy route number in the LGRT parameter.

5.When assigning such a number as shown below to parameter “NPC”, enter “T” code to the end digit of “NPC.”

Example:

When assigning 90 and 900 to NPC:

Number	Input Number for NPC	OPR
90	90T	X
900	900	Y

CHAPTER 4 NDA-24298

Page 302

Issue 1