NEC NDA-24298 manual Aoprn Assignment of Outgoing Pattern Routing Data for NDM

AOPRN : Assignment of Outgoing Pattern Routing Data for NDM

AOPRN: Assignment of Outgoing Pattern Routing Data for NDM

1.General

This command assigns the LCR/LCRS routing pattern for each Outgoing Route Selection Pattern Routing (OPR) number. This command is required when LCR/LCRS activates via Fusion Networking link. The data as- signed by this command is written in the Network Data Memory (NDM) of the Network Control Node (NCN), updating the NDM at each Local Node (LN).

2.Precautions

1.The OPR parameter corresponds to the one assigned by the AFRSN command.

2.The TDPTN parameter is intermediate data to assign the ATCP command. The ATCP command is used to assign the time pattern.

3.The PNL parameter is intermediate data to assign the AADCN command. The AADCN command is used to assign the additional numbers to transmit.

4.The applicable number of additional digits (DC) by the AADCN command varies depending on the PNL data. A maximum of 4 digits of DC is available when the PNL is assigned the range from 1 to127, and a maximum of 24 digits of DC is available when the PNL is assigned the range from 128 to 999.

5.The E parameter is an indicator label of the RA. When E=1 is assigned, more RA assignments are required until E=0 has assigned.

6.The overflow tone can be applied to the originating party if an alternate trunk route has been seized. The OVFT parameter designates whether the overflow tone is or is not provided.

7.The PRSC parameter is referred to as RSC2 of the AEFR command if the “LCR-Controlled Alternate PRSC service is provided. Enter 0 (leave it blank) when the service is not required.

CHAPTER 4 NDA-24298

Page 314

Issue 1