NEC NDA-24298 manual Aunt Assignment of Unit Data

AUNT : Assignment of Unit Data

AUNT: Assignment of Unit Data

1.General

This command assigns the Unit data. It also assigns miscellaneous circuit cards to be mounted in LPM.

2.Precautions

•Prior to assigning the number of the unit data using this command, the ASYD command should be properly assigned.

•The applicable data range in the Module Group Number (MG) parameter is designated by the ASYD command, SYS1, INDEX 0.

•Since the PFT is a mechanical action circuit, the PFT operates properly without any data assignment. However, if the “PFT control by external key” is required, the following data assignments are needed:

(a)AUNT command, TYPE=2 (PFT)

(b)AEKD command

(c)ANCD command

•If the number of the unit’s data deletion is required, you should clear all the station/trunk data within the unit using the ASDT/ATRK commands.

NDA-24298CHAPTER 4

Page 191

Issue 1