NEC NDA-24298 manual Acsa Assignment of Connection Service Index a, Csia

ACSA : Assignment of Connection Service Index A

ACSA: Assignment of Connection Service Index A

1.General

This command assigns the call termination for CAS Line and Direct-in Termination (Day Only).

2.Precautions

1.The ACFR command assignment is also required to assign the trunk incoming call termination service feature.

2.CAS data at the Satellite Station

(a)It is necessary to set the Telephone Class (TEC) of the CAS Line to “15” in the ASDT command.

(b)A ring-down incoming call from a C.O. line is terminated to the CAS Line.

3.When assigning CSIA=3 (Direct-in Termination-outside (Day Only)), the ADC should be assigned by the ASPD command.

4.Use the ACSI command instead of this command if Direct-in Termination (Day and Night Mode) or Direct-in Termination (Night Mode) is required.

5.The applicable Tenant Number (TN) range is designated by the ASYD command, SYS 1, INDEX 8.

3.Data Entry Instructions

CSIA

1 = CAS Line

2 = Direct-In Termination (Day only)

3 = Direct-In Termination-Outside (Day only) 4-7 = Not used

ADC

This parameter is required only for CSIA=3.

				CONNECTION		TERMINATING STATION
	TRUNK										ABBREVIATED
ROUTE				SERVICE
NUMBER	NUMBER			INDEX A	TENANT		STATION NUMBER				DIGIT CODE (ADC)
(RT)		(TN)		(CSIA)	NUMBER				(STN)		MAX. 4 DIGITS
				1-7	(TN)
1	0	0	1	1 or 2	0	1	0	3	1	1 1
2	0	0	1	3						0	0	1	1

CHAPTER 4 NDA-24298

Page 756

Issue 1