NEC NDA-24298 manual Ipx-Umg

ASYD : Assignment of System Data

SYSTEM	SYSTEM	DATA		BIT
			CORRESPONDING
	DATA
DATA		(DATA)		DATA
	INDEX					SYSTEM DATA CONTENTS
TYPE		00 - FF
	(INDEX)
(SYS)		(Hex)	DATA		BIT
	0 - 511
			0/1
					b0	LP28 #0 is mounted on PBI68 Module for IPX-UMG system
					b1	LP28 #1 is mounted on PBI68 Module for IPX-UMG system
			0		b2	Not used
	205		0		b3
					b4	LP30 #0 is mounted on PBI6C Module for IPX-UMG system
					b5	LP30 #1 is mounted on PBI6C Module for IPX-UMG system
			0		b6	Not used
			0		b7
	206	00				Not used
					b0	IP00 System #0
						0/1 = Not mounted/Mounted
					b1	IP00 System #1
						0/1 = Not mounted/Mounted
					b2	IP01 System #0
						0/1 = Not mounted/Mounted
	207				b3	IP01 System #1
						0/1 = Not mounted/Mounted
1					b4	IP02 System #0
						0/1 = Not mounted/Mounted
					b5	IP02 System #1
						0/1 = Not mounted/Mounted
					b6	Not used
					b7	Not used
	208	00				Not used
					b0	Processor Bus No. 0	Processor Bus
						(Usually assign as “1”.)	Indication (for
							IPX-UMG
					b1	Processor Bus No. 1	system).
						(Usually assign as “1”.)	0 = Not Mounted
							1 = Mounted
	209		0		b2~b6	Not used
						If both TSWs in MG are defective, the following functions are
						activated:
			1		b7	• PFT service
						• TSW Fault Message Output
						• Automatic Recover of TSW
						0/1 = Not Required/Required

CHAPTER 4 NDA-24298

Page 138

Issue 1