NEC NDA-24298 manual Chapter

AKYD_T : Assignment of Key Data for Dterm – Telephone Number

16.For Call Forwarding-Busy Line and Call Forwarding-Don’t Answer, refer to ASYD SYS1 Index5 (separate/common access for C.F.-Busy Line and C.F.-Don’t Answer). If common access codes are assigned, only one key is required to activate the features. If separate access codes are assigned, separate function keys must be assigned.

17.<Dterm Series III> The FKY = 55: One-Touch changeover (PAGE) should be assigned when registering destination numbers greater than 20 as one-touch speed calling codes.

<Dterm Series E> The FKY = 55: One-Touch changeover (PAGE) should be assigned when registering destination numbers greater than 16 as one-touch speed calling codes.

Note: Each one-touch button is assigned a 2-page memory (Page 0 and Page 1). One destination number can be assigned on a page basis. When originating an outgoing call, the page of one-touch button can be designated by this function key.

18.In conjunction with intercom service, take the following precautions:

(a)Before assigning the Intercom Key Data using this command, assign the Intercom Group Data using the command AICD/ADIM.

(b)When providing the Intercom service, assign “The response priority when the SPEAKER button is pressed or the station goes off-hook” in the parameter PRI. When not providing the Intercom service, assign PRI = 0.

19.When this command is used, the ELC card must be reinitialized (MB switch UP-DOWN).

20.A maximum of 8 soft keys can be assigned via the function key (FKY=122).

Note: 6 soft keys available at the maximum when page scroll key soft key is displayed on the LCD.

21.Soft key data to be assigned via the function key (FKY=122) is not available for having the different function per each condition on the Dterm.

22.The same function data can not be assigned to both function key and soft key.

23.Expanded Multiple Line Operation - Dterm [E-26] service is available only when “KD = 0 (Line)” is entered. This service is not available when “KD = 1 (Intercom)” or “KD = 2 (DSS Key)” is assigned.

CHAPTER 4 NDA-24298

Page 456

Issue 1