NEC NDA-24298 manual Enter the data of PFT card assigned by the Aunt command

ANCD_LR : Assignment of Night Connection Data – Logical Route Number

ANCD_LR: Assignment of Night Connection Data – Logical Route Number

1.General

This command is used when the Power Failure Transfer (PFT) circuit card is controlled by the external key. Route data of the ANCD command can be assigned by logical route number.

2.Precautions

1.Prior to this command, logical route data must be allocated by using the ALRTN command.

2.Only when logging in to the NCN (Network Control Node), this command can be used to assign the logical route data of self-Node and the other Nodes in the Fusion Network. If logging in to a LN (Local Node), data setting only for the self-node is available. (Error message is indicated if you try to write the data of other Node.)

3.When the “PFT control by the external key” is required, the following data assignments are needed:

(a)AUNT command, TYPE = 2 (PFT)

(b)AEKD command

(c)ANCD/ANCD_LR command

(d)ACSI command, CSI = 4 (Direct-in Termination (Night Mode))

3.Data Entry Instructions

MG

Enter the data of PFT card assigned by the AUNT command.

LGRT

Enter the logical route number allocated to the external route number.

FUSION			PORT	LOGICAL	OUTSIDE	TRUNK
	MODULE	PFT CARD	NUMBER
POINT				ROUTE
	GROUP	NUMBER	OF PFT		ROUTE	NUMBER
CODE				NUMBER			REMARKS
	NUMBER	(NCU PKG)	CARD		NUMBER	(TK)
(FPC)				(LGRT)
	(MG)	0-3	(PORT)		(RT)	1-255
1-253				1-899
			0-11

FPC	TK
Enter the FPC of target Node only when logging	Enter the trunk number connected to the corresponding
in to the NCN (Network Control Node).	circuit number of PFT card.

PORT

The port parameter corresponds to the circuit number of the PFT card.

CHAPTER 4 NDA-24298

Page 768

Issue 1