Location and function of each part
Projector <Top, right and front>
&%$ # 0 | /. | |
' |
| |
| - | |
| ' | |
( | , | |
+ | ||
| ||
) |
| |
* |
|
Projector <Back and bottom> | Preparation |
| |
$ # |
|
| ' |
% |
|
| & |
#Speaker
$Zoom ring (page 23)
%Focus ring (page 23)
&Projection lens
'Air inlet ports
Do not cover this port.
(Front adjustable legs(L/R) (page 22)
)Lens cover
*Leg adjuster buttons(L/R) (page 22)
This button is used to unlock the front adjustable legs. Press to adjust the angle of tilt of the projector.
+Air filter (page 53)
,Remote control signal receptor (page 17)
-MAIN POWER switch (pages 22 and 23)
.SD memory card slot (page 42)
Insert the SD memory card into here after opening the cover.
/Access lamp (page 42)
Flashes while the projector is being accessed for reading or writing the data in the SD memory card.
0Projector control panel (page 14)
#Air outlet port
Do not cover this port.
WARNING
Do not bring your hands or other objects close to the air outlet port.
BHeated air comes out of the air outlet port. Do not bring your hands or face, or objects which cannot withstand heat close to this port, otherwise burns or damage could result.
$Connector panel (page 16)
%Power input socket (AC IN) (page 22)
The accessory power cord is connected here.
Do not use any power cord other than the accessory power cord.
&Lamp unit holder (page 55)
NOTE:
BDuring projection of an image, the cooling fan will operate, emitting
a small noise as it operates. Turning the lamp on or off will cause this noise to increase a little.
BBy using the OPTION menu to set “LAMP POWER” to LOW, the operating sound of the fan can be reduced. (Refer to page 40.)
'Security lock
This can be used to connect a
2855 Campus Drive
San Mateo, CA 94403 USA Tel
Fax
