Philips SCD450 user manual Getting your baby monitor ready EN, Using your baby monitor

Getting your baby monitor ready EN

Small parent unit

A rechargeable battery pack has already been installed in the small parent unit.

1Connect the power adapter cord to the power supply jack

(DC 9V —<+- C-7) of the charging base (C-5).

2Connect the AC power adapter (C-3) to a wall outlet.

3Place the parent unit in the charging base (C-5).

>The charging light (C-6) lights up red.

4Leave the parent unit in the charging base (C-5) until the batteries are fully charged (at least 14 hours).

>When the batteries are fully charged, the charging light (C-5) will gradually dim.The parent unit can now be taken out of the charging base and used cordlessly for up to 10 hours.

>When the POWER light (C-11) flashes red, battery power is low. Place the parent unit in the charging base (C-5) to recharge the batteries.

➜The small parent unit is now ready for use!

Using your baby monitor

1Position all three units in the same room to test the connection. Make sure the baby unit is at least 1 meter / 3 feet away from the parent units.

2Press the ON/OFF button (A-1) to switch on the baby unit.

> The POWER Light (A-7) lights up green.

9