Philips SCD498 manual English, Guarantee and service, Frequently asked questions, Question, Answer

12English

,Batteries contain substances that may pollute the environment. Do not throw away batteries with the normal household waste, but hand them in at an official collection point.Always remove the batteries before you discard or hand in the appliance at an official collection point.

Guarantee and service

If you need information or if you have a problem, please visit the Philips website at www.philips.com or contact the Philips Customer Care Centre in your country (you find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, go to your local Philips dealer or contact the Service Department of Philips Domestic appliances and Personal Care BV.

Frequently asked questions

This chapter lists the questions most frequently asked about the appliance. If you cannot find the answer to your question, contact the Customer Care Centre in your country.

Question	Answer
Why don’t the ON light	Perhaps the batteries of the parent unit are empty and the parent
on the baby unit and the	unit is not in the plugged-in charger. Put the adapter of the charger
LINK light on the parent	in the wall socket and place the parent unit in the charger.Then
unit come on when I press	press the on/off button to establish connection with the baby unit.
the on/off buttons of the
units?
	Perhaps the batteries of the baby unit are empty and the baby unit
	is not connected to the mains. Replace the batteries or put the small
	plug in the baby unit and put the adapter in a wall socket.Then press
	the on/off button to establish connection with the parent unit.
	The baby unit and the parent unit may be out of range of each
	other. Move the parent unit closer to the baby unit, but not closer
	than 1 metre/3 feet.
	If the LINK light on the parent unit still does not start to flash, use
	the reset function to reset the units to their default settings.
Why does the parent unit	If the parent unit beeps while the LINK light flashes red, the
beep?	connection with the baby unit is lost. Move the parent unit closer to
	the baby unit.
	If the parent unit beeps, the LINK light flashes red and the battery
	check light lights up red, the batteries are running low. Recharge the
	batteries.
Why does the appliance	The units may be too close to each other. Make sure the parent unit
produce a high-pitched	and the baby unit are at least 1 metre/3 feet away from each other.
noise?
	The volume of the parent unit may be set too high. Decrease the
	volume of the parent unit.

Why don’t I hear a sound/ Why can’t I hear my baby cry?

The volume of the parent unit may be set too low or may be switched off. Increase the volume of the parent unit.