27
Programming a recording with'TURBO TIMER'With this function, programming a recording that takes place within the next 24 hours, will be
quick and easy. The following pre-set information will appear in the display when you programme
a recording using 'TURBO TIMER'.
Programme number = the programme number currently selected (TV channel)
Start time = current time
End time = current time +2 hours
01
1Press TURBO TIMER on the remote control.
The current set programme number will appear in the display, for
instance, 'PROG. 01'. If required, you can change this using P;q or
P=r .
a'CLK' will flash in the video recorder display
bThis display means that the video recorder clock is not set correctly. Please
read the section 'Setting the time and date' in chapter 'Installing your video
recorder'
20:00
2Press TURBO TIMER .
The current time (= start time) will appear in the display, for instance,
'START 20:00'. If required, you can change this using P;q or
P=r .
22:00
3Press TURBO TIMER .
The end time will appear in the display, for instance, 'END 22:00'.
'END 22:00'. If required, you can change this using P;q or P=r .
4Press TURBO TIMER .
'OK' will briefly appear in the video recorder display. Programming is
now complete.
5Insert a cassette with an intact security tab (unprotected).
6Switch off with STANDBY/ON m.
The programmed recording will only function when the video
recorder is switched off with STANDBY/ON m.
If any of the TIMER blocks are in use, ' k' will light up on the video
recorder display.
ENGLISH
Programming a recording (TIMER)