Philips VR810BPH Setting the Controller to Operate a DBS cont’d, 7Wait for a few seconds

54 Setting the Controller to Operate a DBS (cont’d)

6

Press the PLAY 8 or STOP 9 button to set the two-digit code for your DBS (see list below), then press the OK/STATUS button.

7Wait for a few seconds.

SAT/

CBL/DBS TV VCR

SELECT CODE NUMBER OF YOUR DBS RECEIVER

40

DID DBS RECEIVER

CHANGE TO CHANNEL 205?

A YES

NO

SELECT: 89	CONFIRM:OK
END: MENU

DBS CODES
MAGNAVOX DBS	42, 43
RCA DBS	40
SONY DBS	41	6-8
7

Wait for a few seconds.

•If the DBS changes to channel 205, go to step 8.

•If the DBS doesn’t change to channel 205, press the PLAY 8 or STOP 9 button to select NO, then press the OK/STATUS but- ton. Repeat steps 6-7, using a different code for your brand (if available).

•If the DBS does not respond to any of the codes, press the MENU button to remove the menu. DBS RECEIVER CON- TROL IS OFF will appear on the screen briefly.

8

Press the PLAY 8 or STOP 9 button to select YES, then press the OK/STATUS button. “DBS RECEIVER CONTROL IS ON” will appear for five seconds. “AS A RESULT AUTO CLOCK WILL BE TURNED OFF” may appear on the screen also.

VCR/TV POWER SMARTPICTURE

QUICK PROGRAMMING

1— +* + 2 ABC + 3 DEF

START		STOP	DATE
4 GHI - 5 JKL - 6 MNO
VPS/PDC		DAILY	WEEKLY
7PQRS		8 TUV	9WXYZ
SPEED		DBS/SAT
ALT		0	CLEAR
-	STILL/SLOW			+
	..........		..........
REW				FF
		PLAY

STOP

VOL OK/STATUS CH

MENU

TIMER

TURBO AUDIO/ SKIP TAPE

TIMER MUTE SEARCH MANAGER

JOG/SHTL	REC /OTR
REV	FWD

Helpful Hint

•If your DBS does not respond to the code at step 7, the Controller will not change channels at the DBS during a timer recording. In this case, you must select the channel to be recorded at the DBS before a timer recording begins. Enter the DBS output channel at step 3 on page 40. Leave the DBS on for the timer recording. Details are on page eight.