ENGLISH ADAPTING REMOTE CONTROL
43
43
1Press the MMEENNUUbutton on the remote
control.The on-screen menu appears
AAddaappttiinngg rreemmoottee ccoonnttrrooll
If you are using two video recorders which both react to the same
remote control codes, you can use this function to change remote
control and video recorder to other codes.
2On the remote control press the buttons
SSEELLEECCTTand 22ssiimmuullttaanneeoouussllyy, to set the video
recorder to VCR 2 (or SSEELLEECCTTand 11, to set
it to VCR 1)
3Confirm with OOKK. The screen will show
RESPONDS TO VCR 2 or RESPONDS TO
VCR 1.The on-screen menu disappears The
adjustment of the remote control is
complete
MAIN MENU
CLOCK
AUTO INSTALL
MANUAL SEARCH
TV CHANNEL ALLOC.
RECORD SPEED
AUTO STANDBY
TV SYSTEM
SPECIAL SETTINGS
OK
WWhhaatt aarree rreemmoottee ccoonnttrrooll ccooddeess??
Each time the button on your remote control is
pressed,an invisible infra-red signal is sent to the video
recorder. Each button has been allocated a specific
code,which ensures, that the video recorder will carry
out the corresponding function.If two video recorders
respond to the same codes,the remote control signal
emitted will be recognised and performed by both.
Therefore the possibility exists, to allocate different
remote control commands (with other codes) to this
video recorder.This means that the uninterrupted use
of both video recorders is possible once more. PPAARRDDOONN??
TTIIPP
WWhhaatt mmuusstt II sseett??
If two video recorders respond to the same codes,
they are either both set to VCR 1 or VCR 2.
Please change the setting of only one video recorder!
The factory setting of the video recorder is VCR 1.
PPRROOBBLLEEMM
88MMyy oonn--ssccrreeeenn mmeennuu ddooeess nnoott ddiissaappppeeaarr
44The video recorder does not recognise the change
of remote control codes.Repeat steps 2and 3
88AAfftteerr tthhee bbuuttttoonnss aarree pprreesssseedd VCR 1 oorr VCR 2
aappppeeaarrss iinn tthhee ddiissppllaayy ooff tthhee vviiddeeoo rreeccoorrddeerr
44Repeat step 2to reset the remote control to
the displayed settings