Motorola 3397GP manual PPPoE /PPPoA Settings

PPPoE /PPPoA Settings

You can use the following commands to configure basic settings, port authentication settings, and peer authentication settings for PPP interfaces on your Motorola Netopia® Gateway.

Configuring Basic PPP Settings.

☛NOTE:

For the DSL platform you must identify the virtual PPP interface [vccn], a number from 1 to 8.

set ppp module [vccn] option { on off }

Enables or disables PPP on the Motorola Netopia® Gateway.

set ppp module [vccn] auto-connect { on off }

Supports manual mode required for some vendors. The default on is not normally changed. If auto-con- nect is disabled (off), you must manually start/stop a ppp connection.

set ppp module [vccn] mru integer

Specifies the Maximum Receive Unit (MRU) for the PPP interface. The integer argument can be any number between 128 and 1492 for PPPoE; 1500 otherwise.

set ppp module [vccn] magic-number { on off }

Enables or disables LCP magic number negotiation.

set ppp module [vccn] protocol-compression { on off }

Specifies whether you want the Motorola Netopia® Gateway to compress the PPP Protocol field when it transmits datagrams over the PPP link.

set ppp module [vccn] lcp-echo-requests { on off }

Specifies whether you want your Motorola Netopia® Gateway to send LCP echo requests. You should turn off LCP echoing if you do not want the Motorola Netopia® Gateway to drop a PPP link to a nonre- sponsive peer.

set ppp module [vccn] echo-period integer

Specifies the number of seconds the Motorola Netopia® Gateway should wait before sending another echo from an LCP echo request. The integer argument can be any number from between 5 and 300 (seconds).

187