Your Service Provider will indicate the required vpi number.

set atm [vcc n] vci { 0 ... 65535 }

Select the virtual channel identifier (vci) for VCC n. Your Service Provider will indicate the required vci number.

set atm [vccn] encap { ppp-vcmux ppp-llc ether-llc ip-llc ppoe-vcmux pppoe-llc }

Select the encapsulation mode for VCC n. The options are:

ppp-vcmux

PPP over ATM, VC-muxed

ppp-llc

PPP over ATM, LLC-SNAP

ether-llc

RFC-1483, bridged Ethernet, LLC-SNAP

ip-llc

RFC-1483, routed IP, LLC-SNAP

pppoe-vcmux

PPP over Ethernet, VC-muxed

pppoe-llc

PPP over Ethernet, LLC-SNAP

Your Service Provider will indicate the required encapsulation mode.

set atm [vccn] pppoe-sessions { 1 ... 8 }

Select the number of PPPoE sessions to be configured for VCC 1, up to a total of eight. The total num- ber of pppoe-sessionsand PPPoE VCCs configured must be less than or equal to eight.

Bridging Settings

Bridging lets the Motorola Netopia® Gateway use MAC (Ethernet hardware) addresses to forward non- TCP/IP traffic from one network to another. When bridging is enabled, the Motorola Netopia® Gateway maintains a table of up to 512 MAC addresses. Entries that are not used within 30 seconds are dropped. If the bridging table fills up, the oldest table entries are dropped to make room for new entries.

Virtual circuits that use IP framing cannot be bridged.

NOTE:

For bridging in the 3341 (or any model with a USB port), you cannot set the bridge option off, or bridge ethernet option off; these are on by default because of the USB port.

Common Commands

set bridge sys-bridge {on off }

Enables or disables bridging services in the Motorola Netopia® Gateway. You must enable bridging ser- vices within the Motorola Netopia® Gateway before you can enable bridging for a specific interface.

151

Page 151
Image 151
Motorola 3397GP Set atm vcc n vci 0, Set atm vccn pppoe-sessions 1, Bridging Settings, Set bridge sys-bridge on off, 151