Motorola 3397GP manual Set ip arp-timeout 60, Set ip dsl vccn address ipaddress

TCP/IP services and save the new configuration, the Motorola Netopia® Gateway clears its TCP/IP set- tings.

ARP Timeout Settings

set ip arp-timeout [ 60 ... 6000 ]

Sets the timeout value for ARP timeout. Default = 600 secs (10 mins); range = 60 secs - 6000 secs (1–100 mins).

DSL Settings

set ip dsl vccn address ip_address

Assigns an IP address to the virtual circuit. Enter 0.0.0.0 if you want the virtual circuit to obtain its IP address from a remote DHCP server.

set ip dsl vccn broadcast broadcast_address

Specifies the broadcast address for the TCP/IP network connected to the virtual circuit. IP hosts use the broadcast address to send messages to every host on your network simultaneously.

The broadcast address for most networks is the network number followed by 255. For example, the broadcast address for the 192.168.1.0 network would be 192.168.1.255.

set ip dsl vccn netmask netmask

Specifies the subnet mask for the TCP/IP network connected to the virtual circuit. The subnet mask specifies which bits of the 32-bit binary IP address represents network information. The default subnet mask for most networks is 255.255.255.0 (Class C subnet mask).

set ip dsl vccn restrictions { admin-disabled none }

Specifies restrictions on the types of traffic the Motorola Netopia® Gateway accepts over the DSL vir- tual circuit. The admin-disabledargument means that access to the device via telnet, web, and SNMP is disabled. RIP and ICMP traffic is still accepted. The none argument means that all traffic is accepted.

set ip dsl vccn addr-mapping { on off }

Specifies whether you want the Motorola Netopia® Gateway to use network address translation (NAT) when communicating with remote Gateways. Address mapping lets you conceal details of your network from remote Gateways. It also permits all LAN devices to share a single IP address. By default, address mapping is turned “On”.

set ip dsl vccn auto-sensing [ off dhcp/pppoe pppoe/pppoa ]

Enables or disables DHCP/PPPoE or PPPoE/PPPoA autosensing on the specified interface. Setting this to DHCP/PPPoE enables automatic sensing of your WAN connection type: PPPoE or DHCP. The gate- way attempts to connect using PPPoE first. If the Gateway fails to connect after 60 seconds, it switches to DHCP. As soon as it can connect via DHCP, the Gateway chooses and sets DHCP as its default. Oth- erwise, after attempting to connect via DHCP for 60 seconds, the Gateway switches back to PPPoE.

165