Philips VRX342AT warranty Press the VCR button, then press the Menu button

Setting Up the VCR Plus+ Programming System (cont’d) 37

2

2 Examine the lists on page 36.

Now, compare the channel numbers you have written in the VCR PLUS+ CH. and CABLE/TV CH. columns. You’ll notice that some stations have VCR Plus+ and Cable/TV channel numbers that are the same, and other stations have channel numbers that do not match. Where the channel numbers DO NOT match, you must tell the VCR the VCR Plus+ and Cable/TV channel numbers according to the following steps.

●Make each entry within 60 seconds of the previous entry.

3

Press the VCR button, then press the MENU button.

4

POWER VCR TV

1 2 3

4 5 6

7 8 9

VCR PLUS+
/ENTER
	0	+100
SPEED	TIME SEARCH	MUTE

CABLE /DSS

VCR/TV

CHANNEL

VOLUME

4 6

Press the Number 2 button to select VCR SET UP.

TO SELECT PUSH NO. SHOWN

1 REPEAT PLAY OFF

2 ON SCREEN MODE

	PLAY
– REW			F.FWD +
	STOP
REC/OTR	MEMORY	SLOW	PAUSE/STILL

3	LANGUAGE
4	VCR PLUS+ REF. MAP

TO END PUSH EXIT

5

Press the Number 4 button to select VCR PLUS+ REF. MAP.

VCR PLUS+ CROSS REF. MAP

VCR PLUS+ CABLE/TV

9898

9999

1	– – – – –>	1
2		2

TO SELECT CH PUSH CH UP/

DOWN THEN ENTER CH NO.

TO END PUSH EXIT

3

7

MENU

STATUS/EXIT

CLEAR

EJECT

6

Look at the lists you filled in on page 36. For stations whose

VCR Plus+ and Cable/TV channels do not match, press the CHANNEL (Up/Down) buttons until the arrow is beside the VCR Plus+ channel you need. Then, press the Number buttons to enter the corresponding Cable/TV channel from your list. (Enter a “0” before single-digit chan- nels.) Continue this process until you have entered all the stations on your list.

VCR PLUS+ CROSS REF. MAP

VCR PLUS+ CABLE/TV

9898

9999

1– – – – –> 23

22

TO SELECT CH PUSH CH UP/

DOWN THEN ENTER CH NO.

TO END PUSH EXIT

7

Press the STATUS/EXIT button to exit.

Helpful Hints

•To correct a Cable/TV channel num- ber, repeat the steps on this page.

•To clear a Cable/TV channel number, repeat steps 3-5 on this page. Then, press the CHANNEL (Up/Down) but- tons to select it. Then press the CLEAR button. Press the STATUS/EXIT button to exit.

•Always enter a “0” before single- digit channels.

•To select line input for the Cable/TV channel, press 0,0. AUX will appear on-screen.

•When you receive the VCR from the factory, all the VCR Plus+ channel numbers and Cable/TV channel numbers are the same.