38 Timer Recording With the VCR Plus+ Programming System
Follow the steps below to program a timer recording using the PlusCode programming numbers in your TV guide. Before you begin, make sure:
● Channels are programmed (page 12). |
● The VCR Plus+ and Cable/TV channel numbers are entered |
(pages |
● The clock is set (pages |
● There is a tape in the VCR. Make sure the tape’s record tab is |
intact and the tape is long enough to record the program(s). |
4
1
| VCR | TV | CABLE | |
POWER | /DSS | |||
|
|
● The VCR power is on and the VCR light appears on the display |
panel of the VCR. If it does not, press the VCR/TV button |
once. |
Complete each step within 60 seconds of completing the previous step. If you don’t, you may return to step 1.
1
2
1 2 3
4 5 6
7 8 9
VCR PLUS+ |
|
|
/ENTER |
|
|
| 0 | +100 |
SPEED | TIME SEARCH | MUTE |
VCR/TV
CHANNEL | 3 |
| |
VOLUME |
|
Press the VCR button.
2
Press the VCR PLUS+ /ENTER button on the remote con- trol. The
VCR PLUS+ PROG.
PLUS CODE : – – – – – – – –
| PLAY |
| |
– REW |
| F.FWD + | |
| STOP |
| |
REC/OTR | MEMORY | SLOW | PAUSE/STILL |
MENU | STATUS/EXIT | CLEAR | EJECT |
TO END PUSH EXIT
3
Press the Number buttons to enter the PlusCode pro- gramming number of the program you wish to record (this number is different for every program, and it can be four to eight digits long). Finally, press the VCR PLUS+ /ENTER button.
VCR PLUS+ PROG.
PLUS CODE : 13285 – – –
TO SET PUSH VCR +
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
4
To record the program once, press the Number 1 button to select ONCE. To record the same program every day from Monday through Friday, press the Number 2 button to select DAILY. To record the same program every week on the same day (such as every Saturday), press the Number 3 button to select WEEKLY.
VCR PLUS+ PROG.
1ONCE
2DAILY
3WEEKLY
TO SELECT PUSH NO. SHOWN
TO END PUSH EXIT
Helpful Hints
•If CODE ERROR flashes after you enter the PlusCode programming number and press the VCR PLUS+/ENTER button, the number you entered was incorrect (for exam- ple, too short). If this happens, enter the correct number.
•CLASH may flash on the screen at step 2. This means that the timer recording you just programmed and another timer recording overlap, and thus the current timer recording will not be carried out.
