Installing the LiveGateway Software

Overview

To install the LiveGateway software, use the Setup program described in this section. The LiveGateway Setup
program lets you:
Install the LiveGateway software
Configure the LiveGateway board(s)
Edit Configuration Information
This section contains the following information:
Before You Begin
Upgrading from a Previous Version of LiveGateway
Installing the LiveGateway Software
Configuring the LiveGateway Boards
Entering LiveGateway Configuration Information
Running the LiveGateway Configuration Utility
Starting the LiveGateway Application
Stopping the LiveGateway Application
Accessing the LiveGateway Audio Clip Recorder
Deinstalling LiveGateway

Before You Begin

Perform the following tasks before installing the LiveGateway software:
Identify available IRQ and I/O address settings and reset the board DIP switches if necessary.
Install the LiveGateway board(s).
Prepare the LiveGateway configuration information.
Make sure LiveManager version 3.1 (or other H.323 gatekeeper) has been installed on your network.
Obtain the LiveManager's IP address or name.

Upgrading from a Previous Version of LiveGateway

It is not necessary to deinstall a previous version before you install the LiveGateway software. All configuration
information from a previous version will be maintained. When installing over a previous version of
LiveGateway, the existing install directory is preserved. However, you may need to enter a Gateway Prefix and
a Dialing Prefix (new to LiveGateway versions 3.0 and later).
Note: Stop the previous LiveGateway Service before installing a new version.