Pioneer AVH-P4100DVD operation manual Selecting a cross-over frequency, Using the time alignment

	Section
Available accessories	19

Selecting a cross-over frequency

You can select a frequency, under which sounds are reproduced through the subwoo- fer. If the installed speakers include one whose size has been set to Small, you can select a frequency, under which sounds are repro- duced through a Large speaker or subwoofer.

1Touch Cross Over.

2Touch a or b to select the speaker to be adjusted.

Each time you touch aor b selects the speak- er in the following order:

Front (front speakers)—Center (center speak- er)—Rear (rear speakers)—Subwoofer (sub- woofer)

3Touch c or d to select cross-over fre- quency.

Each time you touch cor d selects cross-over frequencies in the following order: 63Hz—80Hz—100Hz—125Hz—160Hz— 200Hz

Note

Selecting a cross-over frequency is to set a cross- over frequency of the subwoofer’s L.P.F. (low-pass filter) and that of the Small speaker H.P.F. (high- pass filter). The cross-over frequency setting has no effect if the subwoofer is set to Off and other speakers are set to Large or Off.

settings for the speaker over which you hear the test tone are shown in the display. Front-L (front speaker left)—Center (center speaker)—Front-R (front speaker right)— Rear-R (rear speaker right)—Rear-L (rear speaker left)—Subwoofer (subwoofer) Check each speaker output level. If no adjust- ments are needed, perform step 4 to stop the test tone.

#The settings do not appear for speakers whose size is set to Off. (Refer to Setting the speaker setting on page 85.)

3Touch c or d to adjust the speaker out- put level.

Each time you touch cor d it increases or de- creases the equalizer level. +10 to –10 is dis-

played as the level is increased or decreased.

# The test tone rotates to the next speaker after about two seconds from the last operation.

4Touch Stop to stop the test tone out- put.

Notes

!If needed, select speakers and adjust their ‘ab- solute’ output levels. (Refer to Adjusting the speaker output levels on the previous page.)

!To adjust the speaker output levels in this mode is the same as making the speaker out- put levels at Speaker Level (speaker output level). Both provide the same results.

Available accessories

Adjusting the speaker output levels using a test tone

This function allows you to easily get the over- all balance right among the speakers.

1Touch Test Tone.

2Touch Start to start the test tone out- put.

The test tone is outputted. It rotates from speaker to speaker in the following sequence at intervals of about two seconds. The current

Using the time alignment

The time alignment lets you adjust the dis- tance between each speaker and the listening position.

1Touch Time Alignment.

2Touch any of the following touch panel keys to select the time alignment.

!Initial – Initial time alignment (factory set- ting)

En 87