Pioneer AVM-P9000 owner manual Adjustments for Speaker, Operation at the Speaker Setting Menu

5.Cancel the FAD/BAL Setting Menu by clicking the joystick.

Note:

• “F 00” is the proper setting when 2 speakers are in use.

Adjustments for Speaker

You need to make “with/without” (or yes/no) and “size” (bass reproducing capacity) selec- tion/adjustments depending on the installed speakers. The size needs to be set to Large if the speaker is capable of reproducing sounds of about 100 Hz or below. Otherwise select Small.

1.Select “SP Setting” by moving the joystick.

“SP Setting” is highlighted in green.

2.Click the joystick.

The Speaker Setting Menu appears.

The Front Left speaker is highlighted in green and in the lower right-hand corner of the screen the current settings of that speaker is shown.

Operation at the Speaker Setting Menu

	Center
Front Left		Front Right
Rear Left
		Rear Right
Sub Woofer		Show the current settings
		of the selected speaker

• To select a speaker, move the joystick up/down and left/right. You cannot move diagonally.

: Move the joystick left/right. : Move the joystick up/down.

Test Tone:	See “Adjusting the Speakers’ Output
	Levels using a Test Tone” (p. 58).
Cross Over:	See “Selecting a Crossover Frequency” (p. 59).
SW Phase:	See “Correcting the Subwoofer’s Phase” (p. 59).
Audio Setting:	Select this to go to the Audio Setting Menu.
Return:	Completes operations at the Speaker Setting Menu, bringing you back to the
	previous screen.

Continued overleaf.

Adjusting Audio (Basic)

50