Installation
Note:
•Before finally installing the unit, connect the wiring temporarily, making sure it is all con- nected up properly, and the unit and the system work properly.
•Use only the parts included with the unit to ensure proper installation. The use of unautho- rized parts can cause malfunctions.
•Consult with your nearest dealer if installation requires the drilling of holes or other modifica- tions of the vehicle.
•Install the unit where it does not get in the dri- ver’s way and cannot injure the passenger if there is a sudden stop, like an emergency stop.
•When mounting this unit, make sure none of the leads are trapped between this unit and the surrounding metalwork or fittings.
•Do not mount this unit near the heater outlet, where it would be affected by heat, or near the doors, where rainwater might splash onto it.
•Before drilling any mounting holes always check behind where you want to drill the holes. Do not drill into the gas line, brake line, electri- cal wiring or other important parts.
•If this unit is installed in the passenger com- partment, anchor it securely so it does not break free while the car is moving, and cause injury or an accident.
•If this unit is installed under a front seat, make sure it does not obstruct seat movement. Route all leads and cords carefully around the sliding mechanism so they do not get caught or pinched in the mechanism and cause a short circuit.
Installing the Unit
7Mounting with Brackets
Tapping screw (4 ⋅ 12 mm)
Screw
(4 ⋅ 8 mm)
Car mat or chassis | Bracket |
|
Drill 2 to 2.5 mm diameter holes.
7Mounting with Velcro Tape
Thoroughly wipe off the surface before affixing the velcro tape.
Velcro tape
Car mat or chassis
Installation
90