Pioneer CD-BTB200 owner manual Before You Start Information to User, For Canadian model

Section

01 Before You Start

Information to User

FCC ID: AJDK013

MODEL NO.: CD-BTB200

IC: 775E-K013

This device complies with Part 15 of FCC Rules and RSS-Gen of IC Rules. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including inter- ference that may cause undesired operation of this device.

MADE IN THAILAND

This equipment has been tested and found to comply with the limits for a class B digital de- vice, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reason- able protection against harmful interference in a residential installation.

This equipment generates, uses and can radi- ate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio com- munications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment dose cause harmful interfer- ence to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to cor- rect the interference by one or more of the fol- lowing measures:

!Reorient or relocate the receiving antenna.

!Increase the separation between the equip- ment and receiver.

!Connect the equipment into an outlet on a circuit different from that to which the re- ceiver is connected.

!Consult the dealer or an experienced radio/ TV technician for help.

Alteration or modifications carried out without appropriate authorization may invalidate the user’s right to operate the equipment.

This transmitter must not be co-located or op- erated in conjunction with any other antenna or transmitter.

This equipment complies with FCC/IC radiation exposure limits set forth for uncontrolled equipment and meets the FCC/IC radio fre- quency (RF) Exposure Guidelines in Supple- ment C to OET65 and RSS-102 of the IC radio frequency (RF) exposure rules. This equipment has very low levels of RF energy that it is deemed to comply without testing of specific absorption ratio (SAR).

For Canadian model

Operation is subject to the following two condi- tions:

(1)This device may not cause harmful interfer- ence, and (2) this device must accept any inter- ference received, including interference that may cause undesired operation.

This Class B digital apparatus complies with Canadian ICES-003.

4 En