09Additional information
Resetting the main unit
Use this procedure to reset all the receiver's settings to the factory default. Use the front panel controls to do this.
1 Switch the receiver on.
While holding down the TONE button, press and hold the STANDBY/ON button for about three seconds.
2When you see RESET? appear in the display, press the TONE button.
OK? shows in the display.
3Press TONE once more to confirm. OK appears in the display to indicate that the receiver has been reset to the factory default settings.
Cleaning the unit
•Use a polishing cloth or dry cloth to wipe off dust and dirt.
•When the surface is dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and wrung out well, and then wipe again with a dry cloth. Do not use furniture wax or cleansers.
•Never use thinners, benzine, insecticide sprays or other chemicals on or near this unit, since these will corrode the surface.
Specifications (VSX-D414)
Amplifier Section
Continuous Power Output (Stereo RMS)
Front | ........................................................... 120 W |
| (1 kHz, THD 0.2 %, 8 Ω) |
Continuous Power Output (Surround RMS)
Front | 120 W per channel | |
| (1kHz, THD 10 %, 8 | Ω) |
Center | 120 W (1kHz, THD 10 %, 8 | Ω) |
Surround | 120 W per channel | |
| (1kHz, THD 10 %, 8 | Ω) |
Input (Sensitivity/Impedance)
CD, DVR/VCR,
DVD/LD, TV/SAT ........................... 200 mV/47 kΩ
Frequency Response
CD, DVR/VCR,
Output (Level/Impedance)
DVR/VCR REC,
...................................................... | 200 mV/2.2 kΩ |
Tone Control |
|
BASS | ± 6 dB (100 Hz) |
TREBLE | ± 6 dB (10 kHz) |
LOUDNESS .... +6.5 dB/+3 dB (100 Hz/10 kHz)
(at volume level
| |
(IHF, short circuited, A network) |
|
CD, DVR/VCR, |
|
DVD/LD, TV/SAT | 96 dB |
| |
[EIA, at 1 W (1 kHz)] |
|
CD, DVR/VCR, |
|
DVD/LD, TV/SAT | 79 dB |
44
En
