02 5 minute guide
Listening to surround sound
This receiver was designed with the easiest possible setup in mind, so with the following quick setup guide, you should have your system hooked up for surround sound in no time at all. In most cases, you can simply leave the receiver in the default settings.
1 Hook up your DVD player.
For surround sound, you’ll want to hook up using a digital connection from the DVD player to the receiver. You can do this with either a coaxial, or an optical connection (you don’t need to do both). If you hook up using an optical cable, you should refer to Digital input settings on page 35 to assign the optical input to DVD.
Use a video cord to connect the video output on your DVD to the receiver using the jacks shown below.
2 Hook up your TV.
Use a video cord to connect your receiver to the TV using the jacks as shown below.
Optical cable
Note: If you hook up using a optical cable, see Digital input settings on page 35 to assign the optical input to DVD.
DIGITAL OUT
DVD player
7 8
0 | 3 |
VIDEO OUT
S
DIGITAL IN
OPT
1
(TV / SAT)
ASSIGNABLE COAX
2
(CD)
Coaxial | 1 |
cable | COAX |
/LD) | |
| (DVD |
Video cord
This receiver*
VIDEO |
OUT |
IN |
MONITOR |
OUT |
SUB |
WOOFER |
PREOUT |
*The illustration shows
DVD IN | the |
/ LD | connections for the |
FRONT | |
V D | |
1CH | |
IN | same. |
/TAPE / MD
TV
VIDEO IN
Video cord
8
En
