Pioneer P4100UB Using the equalizer, Recalling equalizer curves, Back, Band/Esc, SW Setting

Audio Adjustments

Introduction of audio	Using balance adjustment
adjustments	You can change the fader/balance setting so
1 Press MULTI-CONTROL to display the	that it can provide the ideal listening environ-
	ment in all occupied seats.
main menu.
2 Use MULTI-CONTROL to select AUDIO.	1 Use MULTI-CONTROL to select
	FADER/BALANCE in the audio function
Turn to change the menu option. Press to se-
	menu.
lect.
3 Turn MULTI-CONTROL to select the	2 Press MULTI-CONTROL to display the
	setting mode.
audio function.
Turn MULTI-CONTROL to switch between the	3 Press MULTI-CONTROL to select the seg-
audio functions in the following order.
	ment you wish to set.
FADER/BALANCE (balance adjustment)—
	Press MULTI-CONTROL repeatedly to switch
PRESET EQUALIZER (equalizer recall)—
	between fader and balance.
EQ SETTING 1 (equalizer adjustment)—
EQ SETTING 2 (equalizer fine adjustment)—	4 Turn MULTI-CONTROL to adjust speaker
LOUDNESS (loudness)—SW SETTING 1 (sub-	balance.
woofer on/off setting)—SW SETTING 2 (sub-	Front/rear speaker balance can be adjusted
woofer setting)—HIGH PASS FILTER (high	between FAD F15 and FAD R15.
pass filter)—BASS BOOST (bass boost)—	Left/right speaker balance can be adjusted be-
SRC LV ADJUST (source level adjustment)	tween BAL L15 and BAL R15.
4 Press MULTI-CONTROL to display the	# You can also perform the same operations by
	pushing MULTI-CONTROL up or down.
setting mode of each function.
	# FAD 0 is the proper setting when only two
5 Adjust the each function.	speakers are used.
	# When the rear output setting is SUB W, ad-
Notes	justing the front/rear speaker balance is not effec-
	tive. Refer to Setting the rear output and
! You can also select the audio function by
	subwoofer controller on page 30.
pressing AUDIO on the remote control.
! To return to the previous display, press BACK.
! To return to the main menu, press and hold	Using the equalizer
BACK.
	The equalizer lets you adjust the equalization
! To return to the ordinary display, press
BAND/ESC.	to match the car’s interior acoustic character-
! You can select the SW SETTING 2 only when	istics as desired.
subwoofer output is turned on in
SW SETTING 1.	Recalling equalizer curves
! When selecting FM as the source, you cannot
	There are six stored equalizer curves which
switch to SRC LV ADJUST.
	you can easily recall at any time. Here is a list
! If you do not operate functions within about
	of the equalizer curves.
30 seconds, the display automatically returns
to the ordinary display.

Section

03

English

En 25