Preparation | 05 |
Antenna cable (commercially available)
If your outdoor antenna uses a
Note
•If the antenna is not connected correctly, the quality of reception may be impaired. If images are not displaying correctly, check whether the antenna connection is correct or not.
Routing cables
Use the speed clamps as necessary to route the connecting cables. The diagrams below show the location of the holes on the rear of the display.
Tidying the speaker cables (PDP-508XG only)
Use the supplied bead bands as necessary to tidy the speaker cables.
Rear view | Speaker cable |
|
Bead band
Attaching the ferrite core
(when a ferrite core is not attached)
To help prevent noise, attach the supplied ferrite core to the connector end of the power cord as shown. Use the supplied cable tie to prevent the ferrite core from slipping on the cable.
1
2 | 3 | 4 |
|
Ferrite core
Cable tie
To power outlet
AC power cord
As close as possible
Connecting the power cord
English
Attaching and removing speed clamps
Insert [1] into an appropriate hole on the rear of the plasma television and snap [2] into the back of [1] to lock the clamp.
2
1
•Speed clamps are designed to be difficult to undo once in place. Please attach them carefully.
•Use pliers to twist the clamp 90º, pulling outward. The clamp may deteriorate over time and become damaged if removed.
•Be careful not to subject any connecting cables to strain.
Note
• Use the speed clamps as necessary.
Rear view
Power cord 
Note
Ferrite core
Partially eliminates noise caused by the power source.
To power outlet
•Disconnect the power cord from the power outlet when the plasma television is not going to be used for a long period of time.
•After all other components are connected, connect the power plug to the AC outlet.
17
En
