Pioneer PDP-436RXE manual Watching TV, Turning on/ off the power, Plasma Display status indicators

06Watching TV

Unless you set up TV channels that you can watch under the current conditions, you cannot tune in those channels. For the procedure, see “Setting up TV channels automatically” on page 24.

Turning on/ off the power

To turn on the system, press POWER on the Plasma Display.

•The POWER ON indicator on the Plasma Display lights up in blue.

To turn off the system, press aon the remote control unit or STANDBY/ON on the Plasma Display.

•The Plasma Display is placed into the standby mode; STANDBY indicator lights up in red.

•You can then turn on the system again by pressing aor 0 to 9 on the remote control unit or STANDBY/ON on the Plasma Display. If you press 0 on the remote control unit, images come from the INPUT 1 source. If you press 1 to 9, TV images display.

You can also press POWER on the Plasma Display to turn off the system. However, you cannot then turn on the system

again by pressing the buttons on the remote control unit or STANDBY/ON on the Plasma Display.

NOTE

•If you are not going to use the Plasma Display System for a long period of time, be sure to remove the power cord from the power outlet.

•When the system is placed into the standby mode, the main power flow is cut and the system is no longer fully operational. A minute flow of power feeds the system to maintain operation readiness.

Plasma Display status indicators

The table below shows the operational status of the Plasma Display System. You can check the current status of the system with the indicators on the Plasma Display.

Plasma Display

STANDBY
indicator
POWER ON indicator	STANDBY/ON button
POWER button

Indicator Status		System Status
Plasma Display
POWER ON	STANDBY
		The power cord of the Plasma Display has been disconnected. Or, the power cord of the Plasma Display has been
		connected but the POWER button of the Plasma Display is off.
		Power to the system is on.
		The system is in the standby mode.

For other than the above, see “Troubleshooting” on page 43.

18

En