Pioneer PDP-436RXE manual Preparation, Stabilizing on a table or floor, Location

05	Preparation
	Installing the Plasma Display	Preventing the Plasma Display from
		Falling Over
		After installing the stand, be sure to take special care to ensure
		that the Plasma Display will not fall over.
		Stabilizing on a table or floor
		Stabilize the Plasma Display as shown in the diagram using
	Over 50 cm	screws that are available on the market.
		NOTE
		To stabilize the Plasma Display on a table or on the floor, use
		screws that have a nominal diameter of 6 mm and that are at
		least 20 mm long.
	Over
	10 cm

Location

•Avoid direct sunlight. Maintain adequate ventilation.

•Because the Plasma Display is heavy, be sure to have someone help you when moving it.

CAUTION

•If you do not leave sufficient space above the Plasma Display, it will not receive enough ventilation and will not operate properly.

NOTE

•Allow enough space around the upper and back parts when installing to ensure adequate ventilation of the rear of the unit.

Using the optional PIONEER stand

For details on installation, refer to the instruction manual supplied with the stand.

CAUTION

Operating Environment

Operating environment temperature and humidity:

+0 ºC – +40 ºC; less than 85 %RH (cooling vents not blocked) Do not install this unit in a poorly ventilated area, or in locations exposed to high humidity or direct sunlight (or strong artificial light)

CAUTION

A table or an area of the floor with adequate strength should always be used to support the Plasma Display. Failure to do so could result in personal injury and physical damage.

When installing the Plasma Display, please take the necessary safety measures to prevent it from falling or overturning in case of emergencies, such as earthquakes, or of accidents.

If you do not take these precautions, the Plasma Display could fall down and cause injury.

The screws, hooks, chains and other fittings that you use to secure the Plasma Display to prevent it from overturning will vary according to the composition and thickness of the surface to which it will be attached.

Select the appropriate screws, hooks, chains, and other fittings after first inspecting the surface carefully to determine its thickness and composition and after consulting a professional installer if necessary.

14

En