Pioneer PRO-950HD manual Preparation

Preparation 05

Connecting the speaker cables	Connecting the speaker cables
to the rear of plasma display.	to the speaker.

Gray Black Gray

Red Black Red

Black￿

Black

Red￿

Gray

Connect the cables correctly with respect to the polarity of the plasma display speaker terminals, that is, ￿ cable (Gray) to ￿ terminals (Red) and ￿ cable (Black) to ￿ terminals (Black).

Connect the cables correctly with respect to the polarity of the speaker terminals, that is, ￿ cable (Gray) to ￿ terminals (Red) and ￿ cable (Black) to ￿ terminals (Black).

Speaker terminal

Speaker terminal Speaker cable

Note

•Press the lever and insert the end of the cable.

•When you release the lever, it

clamps onto the speaker cable.·

Caution

Lever

•Be sure to turn the connected devices off and remove the power

cord from the wall outlet beforehand when changing the connection or installation method.

•If you insert the speaker cable too far so that

the insulation is touching the speaker terminal, you may not get any sound.

Speaker terminal

•Check if the end of the speaker cables are securely connected to the terminals by slightly tugging on the cable after making connections. Loose connections may result in sound dropouts or noise.

•If there is a short in the and cables caused by an exposed lead wire, excessive load may be applied to the plasma display, resulting in interrupted operation or malfunction.

•Incorrect connections of the speaker cable to the right or left of the plasma display terminals with respect to the polarity may result in insufficient stereo sound effects, delivering poor bass sounds or unstable sound image.

•Bundle the cable without pulling.

19

En