Pioneer PRO-950HD manual Attach the speaker mounting fittings to the speakers

Preparation 05

PRO-1150HD with the speaker installed (with the Pioneer table top stand)

Speaker mounting fitting	Speaker mounting		Speaker mounting	Speaker mounting fitting
(for TOP-RIGHT)				(for TOP-LEFT)
	screw (M5 x 10 mm)		screw (M5 x 10 mm)
Speaker mounting screw				Speaker mounting screw
(M5 x 10 mm)				(M5 x 10 mm)
Speaker				Speaker
		Bead band
		(Accessories of the
Speaker mounting fitting	Speaker mounting	plasma display)	Speaker mounting	Speaker mounting fitting
	screw (M5 x 10 mm)		screw (M5 x 10 mm)
(for BOTTOM-RIGHT)				(for BOTTOM-LEFT)

Speaker mounting screw Speed clamp
(M5 x 10 mm)	Speaker cable

Note

•Before installing the speaker, make sure that the Pioneer table top stand is attached to the plasma display.

•When using the hang on wall unit, first lay the plasma display on top of a soft sheet, etc., remove the stand, then attach the speaker.

1.Attach the speaker mounting fittings to the speakers.

•There is a left speaker and a right speaker. When you are mounting them, check the label on the back to get them right.

•There are top and bottom speaker mounting fittings for both the left and the right speaker. Attach the appropriate fittings to the top and the bottom on the back of the speakers using the supplied screws.

(It shows the attachment of the fitting on the right side. It is attached on the left side by the same procedure.)

Speed clamp Speaker mounting screw (M5 x 10 mm)

Speed clamp

Speaker mounting fitting (For TOP-RIGHT)

(The skinny slot is used for mounting to the top.)

Speaker mounting fitting (For BOTTOM-RIGHT)

Screw holes

Screw holes

Speaker mounting fitting (For TOP-RIGHT)

Speaker mounting fitting (For BOTTOM-RIGHT)

Place the speaker so its terminals (bottom) are facing you.

17

En