Pioneer PRO-950HD manual Attaching/detaching the Pioneer stand, Detaching the stand

Preparation

Attaching/detaching the Pioneer stand

The plasma display comes with the Pioneer table top stand attached. You can also install the display on a rack by detaching the stand. The method for attaching/detaching the stand varies depending on the product.

Caution

•This product can be used only with the attached stand. Using other stands can result in instability, possibly causing injury.

•The weight of a 50 inch plasma display is about 34.8 kg (76.7 lbs.) and a 42 inch about 29.9 kg (65.9 lbs.), it has no depth, and is unstable. Therefore, at least two people must assemble and install it.

Detaching the stand

•Steps for detaching the stand are the same for PRO- 1150HD and PRO-950HD. Illustrations shown are for PRO- 1150HD.

1With the plasma display lying flat, loosen and remove the two installation bolts (1) and (2) using a screwdriver.

Installation bolts (1): M8 x 23 mm (black) for PRO-950HD M8 x 23 mm (black) for PRO-1150HD

Installation bolts (2): M8 x 60 mm (black) for PRO-950HD M8 x 40 mm (black) for PRO-1150HD

Installation bolts (1) (Step 1)

Installation bolts (2) (Step 2)

Table top stand

Sheet

2Remove the stand from the plasma display.

05

Note

•Make sure to keep the installation bolts (1) and (2) that have been removed as they are re-used when attaching the stand to the plasma display.

•Place a sheet or protective cover to protect the display from scratches or damage.

•Work only with the plasma display lying flat on a table or similar surface.

•When lying the plasma display down, be careful not to scratch or damage it.

•If the speaker has been installed, it is recommended to detach the speaker before removing the stand (for PRO-1150HD only).

Attaching the stand again

•Steps for attaching the stand are the same for PRO- 1150HD and PRO-950HD (use the screw holes with “T” inscribed). Illustrations shown are for PRO-1150HD.

1With the plasma display lying flat, fit the stand’s support columns to the bottom of the plasma display as indicated by the arrows, then slowly insert them.

•Be extremely careful not to insert the support columns of the stand into any part of the plasma display other than the stand insertion slots. Doing so might damage the plasma display panel or its ports or result in warping of the stand.

Line up the column supports with the bottom of the plasma display, as indicated in the accompanying diagram.

Plasma display

Insert the stand into the	Sheet
plasma display so that an
arrow with “FRONT/FACE
AVANT” mark inscribed at
the bottom of the stand
indicates downward.

21

En