04 
Controls and displays
MPX*
Switches between stereo and mono reception of FM broadcasts. If the signal is weak then switching to mono will improve the sound quality (page 43).
D. ACCESS*
After pressing, you can access a radio station directly using the number buttons (page 43).
MIDNIGHT
Switches to Midnight or Loudness listening (page 31).
ANALOG ATT
Attenuates (lowers) the level of an analog input signal to prevent distortion.
DIMMER
Dims or brightens the display.
SLEEP
Press to change the amount of time before the receiver switches into standby (30 min
–60 min – 90 min – Off). You can check the remaining sleep time at any time by pressing SLEEP once.
SIGNAL SEL
Use to select an input signal (page 32).
SB ch
Selects the surround back channel mode (page 30) or virtual surround back mode
(page 31).
9 INFO
Use to bring up information screens on a digital TV.
10 SHIFT
Press to access the ‘boxed’ commands (above the buttons) on the remote. These buttons are marked with an asterisk (*) in this section.
11 Remote control LED
Lights when a command is sent from the remote control.
26
12 SOURCE
Press to turn on/off other components connected to the receiver (see page 48 for more on this).
13 RECEIVER
Switches the remote to control the receiver (used to select the green commands above the number buttons (SETUP, etc). Also use this button to set up surround sound (page 8, page 34).
14 TV CONTROL buttons
These buttons are dedicated to control the TV assigned to the TV CTRL button. Thus if you only have one TV to hook up to this system assign it to the TV CTRL MULT CONTROL button. If you have two TVs, assign the main TV to the TV CTRL button (see page 48 for more on this).
Use to turn on/off the power of the TV.
INPUT SELECT
Use to select the TV input signal.
TV CH +/–
Use to select channels.
TV VOL +/–
Use to adjust the volume on your TV.
Operating range of remote control
The remote control may not work properly if:
•There are obstacles between the remote control and the receiver’s remote sensor.
•Direct sunlight or fluorescent light is shining onto the remote sensor.
•The receiver is located near a device that is emitting infrared rays.
•The receiver is operated simultaneously with another infrared remote control unit.
30
30
7 m (23 ft.)
En
