5 minute guide | 02 |
6Follow the instructions on-screen.
•Make sure the microphone is connected.
•If you’re using a subwoofer, it is automatically detected every time you switch on the system. Make sure it is on and the volume is turned up.
•See below for notes regarding background noise and other possible interference.
7Wait for the test tones to finish.
A progress report is displayed
2.Auto MCACC
Now Analyzing |
| ||
|
|
|
|
Environment Check |
| ||
Ambient Noise | [ OK ] | ||
Microphone | [ OK ] | ||
Speaker YES/NO | [ OK ] | ||
|
|
| :Cancel |
•For correct speaker settings, do not adjust the volume during the test tones.
8Confirm the speaker configuration. The configuration shown
2.Auto MCACC
| Check! | |||
Front | [ YES ] |
| ||
Center | [ YES ] |
| ||
Surround | [ YES ] |
| ||
SB | [ Yx2 ] |
| ||
SUB W. | [ YES ] |
| ||
|
|
|
|
|
|
|
|
|
|
|
|
| OK | |
30:Next |
|
| :Cancel |
|
If the speaker configuration displayed isn’t correct, use / to select the speaker and / to change the setting (and number for surround back). When you’re finished, go to the next step.
If you see an error message (ERR) in the right side column, there may be a problem with the speaker connection. If selecting RETRY doesn’t fix the problem, turn off the power and check the speaker connections.
9Make sure ‘OK’ is selected, then press
ENTER.
If the screen in step 8 is left untouched for 30 seconds, and the ENTER button is not pressed in step 9 the Auto MCACC setup will start again from the beginning.
A progress report is displayed
2.Auto MCACC
Now | Analyzing |
|
| |||
|
|
|
|
|
|
|
Surround | Analyzing |
|
| |||
Speaker | System | [ | ] | |||
Speaker | Distance | [ | ] | |||
Channel | Level | [ | ] | |||
Acoustic | Cal EQ | [ | ] | |||
:Cancel
Again, try to be as quiet as possible while this is happening. It may take 3 to 8 minutes.
10The Auto MCACC Setup has finished! Select ‘SKIP’ to go back to the System Setup menu.
The MCACC indicator on the front panel will light to show the setup is complete.
The settings made in the Auto MCACC Setup should give you excellent surround sound from your system, but it is also possible to adjust these settings manually using the System
Setup menu (starting on page 34).1
You can also choose to view the settings by selecting individual parameters from the Analyzed Data Check screen:
English Deutsch Français Italiano Nederlands Español
Note
1• Depending on the characteristics of your room, sometimes identical speakers with cone sizes of around 12 cm (5 inches) will end up with different size settings. You can correct the setting manually using the Speaker Setting on page 40.
•The subwoofer distance setting may be farther than the actual distance from the listening position. This setting should be accurate (taking delay and room characteristics into account) and generally does not need to be changed.
9
En
