Pioneer VSX-91TXH manual Advanced Mcacc output using your PC

Other connections 08

Please make sure your system meets the following requirements:

•Operating system must be Windows® XP, Windows® 2000, Windows® Millennium Edition, Windows® 98 Second Edition, or Windows® NT 4.0 (Service pack 6).

•CPU must be at least Pentium 3 / 300 MHz or AMD K6 / 300 MHz (or equivalent) with at least 128 MB of memory, and your monitor must be able to display a minimum resolution of 800x600.

•An RS-232C port connector is necessary for graphical output. Refer to the operating instructions and/or the PC manufacturer for more information on making the proper port settings.

•System must have internet access.

•Connect your computer to the RS-232C jack on the rear panel of the receiver.

Make sure that the receiver and all connected components are switched off and disconnected from the power outlet when you do this.1

Use a commercially-available cable to connect the RS- 232C jack on your computer to the 9-pin RS-232C jack on this receiver. See the documentation provided with the Advanced MCACC application for more information.

RS-232C

PC

Advanced MCACC output using your PC

Before continuing, make sure you have completed steps 1 to 3 in Professional Acoustic Calibration EQ on page 39. Note that transmission data is erased when the receiver is turned off.

1Select ‘Reverb Output PC’ and press ENTER. When the receiver is ready for transmission, Start the MCACC application on your PC shows on the OSD.

3e.EQ Professional			3e3.Reverb Output PC
	1.Reverb Measurement		MCACC:M1. MEMORY 1
	2.Reverb View
	3.Reverb Output	PC	Start the MCACC
	4.Advanced EQ	Setup
			application on your PC
ENTER:Next		:Return	:Cancel

2Start the MCACC application on your computer. Follow the instructions provided with the application. It will take about ten seconds for the transmission to complete, then you will be able to analyze the output on your computer. Since the data will be cleared from the receiver when you restart reverb measurement or turn off the receiver, you might want to save the information on your PC after measurement.

3When you’re finished, press RETURN.

You’ll be taken to the Advanced EQ Setup. Depending on the results, you may want to continue with the Advanced EQ setup (see Professional Acoustic Calibration EQ on page 39 for more on this). You can also simply press RETURN again to exit the Professional Acoustic Calibration EQ setup.

Note

1Make sure that you do this before continuing to the Reverb Measurement option in Professional Acoustic Calibration EQ on page 39 (measurement data is cleared if you switch off the power).

59

En