Pioneer VSX-LX52 manual Connecting your equipment, Make sure that the receiver and all connected

Connecting your equipment

•Connect your computer to the RS-232C jack on the rear panel of the receiver.

Make sure that the receiver and all connected

components are switched off and disconnected from the power outlet when you do this.1

Use a commercially-available cable to connect the RS- 232C jack on your computer to the 9-pin RS-232C jack on this receiver. See the documentation provided with the Advanced MCACC application for more information.

HDMI		BD IN	IN 1		IN 2	IN 3		OUT 1 (KURO		OU
ASSIGNABLE									LINK)
1	3
COMPONENT
VIDEO
ASSIGNABLE
IN 1		IN 2
(DVD)		(DVR) L
Y		Y
			R
PB		PB
			ZONE2	ZONE3	DVD	TV/SAT	VIDEO		DVR
PR		PR	OUT	OUT	IN	IN	IN	OUT	IN
				MONITOR
				OUT
Y		MONITOR	VIDEO
		OUT
PB
				S-VIDEO
PR								12 V TRIGGER

	CONTROL	IR	(OUTPUT 12 V
RS-232C	IN OUT	IN 1 IN 2 OUT	TOTAL 50 mA MAX)
			1	2

03

Connecting an HDMI-equipped component to the front panel input

There is an HDMI input terminal on the front panel. High quality pictures can be viewed via the receiver simply by connecting an HDMI-equipped video camera with a single HDMI cable. HDMI-equipped components other than video cameras can also be connected to this terminal.

•Push down on the PUSH OPEN tab to access the front panel input.

•Select this input using INPUT SELECT (remote) or the INPUT SELECTOR dial (front panel) to select HDMI 4.

		MASTER
CONTROL	ON/OFF	VOLUME
		VIDEO CAMERA
	iPod
	iPhone
MCACC SETUP MIC	USB	HDMI 4

This receiver

RS-232C

Personal computer

Video camera, etc.

Note

1The various parameters and the reverb characteristics data used for display on the computer are not cleared when the power is turned off (see Output PC on page 81).

35

En