Pioneer VSX-LX52 manual Grounding purposes, Connecting your equipment Connecting an IR receiver

Connecting your equipment

Connecting an IR receiver

If you keep your stereo components in a closed cabinet or shelving unit, or you wish to use the sub zone remote control in another zone, you can use an optional IR receiver (such as a Niles or Xantech unit) to control your system instead of the remote sensor on the front panel of this receiver.1

1Connect the IR receiver sensor to the IR IN jack on the rear of this receiver.

Closet or shelving unit

PioneerNon-Pioneer

component component

	CONTROL							IR
	IN	OUT						IN
HDMI		BD IN		IN 1		IN 2	IN 3
ASSIGNABLE
1	3
COMPONENT
VIDEO
ASSIGNABLE
IN 1			IN 2
(DVD)			(DVR) L
Y			Y
				R
PB			PB
				ZONE2	ZONE3	DVD	TV/SAT	VIDEO
PR			PR	OUT	OUT	IN	IN	IN
					MONITOR
					OUT

03

Operating other Pioneer components with this unit’s sensor

Many Pioneer components have SR CONTROL jacks which can be used to link components together so that you can use just the remote sensor of one component. When you use a remote control, the control signal is passed along the chain to the appropriate component.2

Important

•Note that if you use this feature, make sure that you also have at least one set of analog audio, video or HDMI jacks connected to another component for

grounding purposes.

1 Decide which component you want to use the remote sensor of.

When you want to control any component in the chain, this is the remote sensor at which you’ll point the corresponding remote control.

2 Connect the CONTROL OUT jack of that component to the CONTROL IN jack of another Pioneer component.

Use a cable with a mono mini-plug on each end for the connection.

Y	MONITOR	VIDEO
	OUT
PB
		S-VIDEO
PR			1
		CONTROL	IR
	RS-232C	IN OUT	IN 1 IN 2 OUT

DVR

YY

PBPB

PRPR

MONITOR

YOUT

PB

PR

RS-232C

R

ZONE2	ZONE3	DVD	TV/SAT	VIDEO
OUT	OUT	IN	IN	IN
	MONITOR
	OUT
VIDEO
	S-VIDEO
				1
CONTROL			IR	(
				T
IN	OUT		IN 1 IN 2	OUT

IR receiver

2Connect the IR IN jack of another component to the IR OUT jack on the rear of this receiver to link it to the IR receiver.

Please see the manual supplied with your IR receiver for the type of cable necessary for the connection.

•If you want to link a Pioneer component to the IR receiver, see Operating other Pioneer components with this unit’s sensor below to connect to the CONTROL jacks instead of the IR OUT jack.

IN	OUT	IN	OUT
CONTROL		CONTROL

Continue the chain in the same way for as many components as you have.

Note

1• Remote operation may not be possible if direct light from a strong fluorescent lamp is shining on the IR receiver remote sensor window.

•Note that other manufacturers may not use the IR terminology. Refer to the manual that came with your component to check for IR compatibility.

•If using two remote controls (at the same time), the IR receiver’s remote sensor takes priority over the remote sensor on the front panel.

2• If you want to control all your components using this receiver’s remote control, see Setting the remote to control other components on page 67.

•If you have connected a remote control to the CONTROL IN jack (using a mini-plug cable), you won’t be able to control this unit using the remote sensor.

33

En