Pioneer VSX-LX52 manual Remote control, Hdmi, Additional information, SBch AUTO setting, EX or ES

Additional information 12

Symptom	Remedy
During playback of a Surround	• The source may be Dolby Surround EX/DTS-ES software, but it has no flag to indicate it is 6.1
EX or DTS-ES source on the	compatible. Set to SBch ON (see Using surround back channel processing on page 53), then switch
SBch AUTO setting, EX or ES	to the THX Surround EX or Standard EX listening mode (see Listening in surround sound on page 50).
does not appear, or the signal
is not properly processed.
During playback of DVD-Audio,	• This will occur when playing DVD-Audio material over the HDMI connection. This is not a
the display shows PCM.	malfunction.
The power turns off	• See the Power section (page 92).
automatically and some
indicator flashes, or some
indicator flashes and the power
does not turn on.

Remote control

Symptom	Remedy
Cannot be remote controlled.	• Set a 5-digit preset code corresponding to the receiver to be operated in the remote control (see
	Operating multiple receivers on page 67).
	• Check whether the receiver’s remote control mode is properly set (see Remote Control Mode Setup
	on page 90).
	• Try replacing the batteries in the remote control (see Loading the batteries on page 8).
	• Be sure to operate within 7 m and a 30º angle of the remote sensor on the front panel (see
	Operating range of remote control unit on page 8).
	• Check that there are no obstacles between the receiver and the remote control.
	• Make sure that there is no fluorescent or other strong light shining on to the remote sensor.
	• Check the connections of the CONTROL IN jack (see Operating other Pioneer components with this
	unit’s sensor on page 33).
Other components can’t be	• If the battery ran down, the preset codes may have been cleared. Re-enter the preset codes.
operated with the system	• The preset code may be incorrect. Redo the procedure for entering preset codes.
remote.

HDMI

Symptom	Remedy
The HDMI indicator blinks	• Check all the points below.
continuously.
No picture or sound.	• This receiver is HDCP-compatible. Check that the components you are connecting are also HDCP-
	compatible. If they are not, please connect them using the component, S-Video or composite video
	jacks.
	• Depending on the connected source component, it’s possible that it will not work with this receiver
	(even if it is HDCP-compatible). In this case, connect using the component, S-Video or composite
	video jacks between source and receiver.
	• If the problem still persists when connecting your HDMI component directly to your monitor,
	please consult the component or monitor manual or contact the manufacturer for support.
	• If video images do not appear on your TV or flat screen TV, try adjusting the resolution, DeepColor
	or other setting for your component.
	• While analog video signals are being output over HDMI, use a separate connection for audio
	output.
	• When this receiver reproduces MULTI CH IN audio sources with the HDMI setting set to
	THROUGH, you cannot hear audio output from all channels. In this case, make a digital or analog
	audio connection.
	• To output signals in DeepColor, use an HDMI cable (High Speed HDMI™ Cable) to connect this
	receiver to a component or TV with the DeepColor feature.
No picture.	• Try changing the Resolution setting (in Setting the Video options on page 61).
	• Set the HDMI output setting to the connected HDMI OUT terminal (in Switching the HDMI output
	on page 65).

97

En